Step-by-step production process.
Irnas Lacuna space modem v0.2
add GPS antenna (1590MHz/1594MHz ??)
other side: RF connector (=elephant)
remove all components from the top - keep antenova
add 0-ohm resistor
add picoblade connector (see images 2-5)
battery 5-pack assembly
add wires to the battery pack
plastic enclosure production
washing of the enclosure
aluminium lid production
anodisation of the aluminium lid
screw holes indentation on attachment plates
polishing of the attachment plates
assembly of electronics inside the hardware
assembly of the hardware - enclosure + lid (screws: 14x DIN7985 M4x12 rust-free /tracker)
engraving of serial numbers (laser parameters: power 30%, speed 250 mm/s)
TPU leather flat belt production (BioThane Granite 230 TPU Coated Webbing, colour TN232)
width: 50 mm
length: 1.2 m
logo engraving (cutting: power 100%, speed 10 mm/s, scanning: power 40%, speed 250 mm/s)
TPU leather flat belt production (BioThane Granite 230 TPU Coated Webbing, colour TN232)
width: 50 mm
length: 1.2 m
logo engraving (cutting: power 100%, speed 10 mm/s, scanning: power 40%, speed 250 mm/s)